What do the LED lights mean on Multitech Conduit IP67 gateways?

What do the LED lights mean on Multitech Conduit IP67 gateways?


LED Indicators

Label

Name

Description

PWR

Power

Solid (constant) green if unit is on indicating that DC power is present.

STATUS

Power Status

Default condition: LED blinks when mLinux is fully loaded.

LS (or L1)

Link Status

Varies with radio model. (See below.)

A-B-C-D

–

These 4 LEDs are user-specified. Present on the Conduit mLinux model only.

CD (L2)

Carrier Detect

This LED is on when a cellular data connection is made. Present on the Conduit Application model only.

Signal

Signal Strength

These 3 LEDs display the strength of the cellular signal. Present on the Conduit Application model only.


Typical LS (Link Status) or L1 LED Behavior

If a cellular radio such as EV3, H5, LAT1, LVW2, LAT3, LVW3, LNA3, or LDC3 is installed, the typical LS (Link Status) (or L1) LED behavior is:

  1. OFF – No power to the cellular radio
  2. Continuously Lit – Not registered to any cellular network
  3. Slow Blink (~0.2 Hz) – Registered or connected to cellular network

    • Related Articles

    • Multitech Conduit Gateway Troubleshooting

      Multitech Conduit LoRaWAN gateway should be connected to "P+D/OUT" port of the PoE Injector. If you have internet (from a router's ethernet), you can connect it to "Data/IN" of the PoE Injector. If you don't connect internet line to "Data/IN", the ...

    • Debug No Connectivity Issue on Multitech Conduit LoRa Gateway (ethernet only version)

      If the Multitech (ethernet-only) gateway completely stops connecting to the internet, not just our LoRa network server. Since this is an Ethernet-only gateway, the most likely failures are: Power failure (ie. PoE Injector failure, mains power loss - ...

    • Installing a Multitech Gateway

      In order to setup your Multitech Gateway with your Zenseio Device, follow these simple steps: Fill-out request form, so Zenseio Support can onboard your Gateway in our system. Insert the SIM card into the SIM slot under the round clear plastic window ...

    • Setting Up a Multitech Gateway: Hardware Installation Guides & Tips

      When setting up and installing a MultiTech Gateway for use with your Zenseio device, we advise referring to the official hardware installation guide before mounting. Note that the installation process can vary by model, so be sure you are using the ...

    • Reducing Signal Interference for a LoRa Gateway

      If the gateway is missing lots of LoRa messages, it could be due to strong radio interference from other telecomunications equipment mounted close to the gateway. Relocating the gateway as far as you can from the interference source would be the best ...