Setting Up a Multitech Gateway: Hardware Installation Guides & Tips

Setting Up a Multitech Gateway: Hardware Installation Guides & Tips

When setting up and installing a MultiTech Gateway for use with your Zenseio device, we advise referring to the official hardware installation guide before mounting. Note that the installation process can vary by model, so be sure you are using the right guide for your particular gateway. The following manuals can be used for hardware installation: 
  1. Multitech Conduit® IP67 Base Station 200 Series 
  2. Multitech Conduit® IP67 Base Station 
  3. Multitech Conduit AP
Before installing and mounting your gateway, make sure to insert your activated SIM card and test your gateway is working correctly.

Zenseio recommends fully testing that your gateway is functioning properly before mounting. After initial setup, you can check if the gateway is working using the manufacturers included dashboard.
If your device needs any custom configuration for your particular application, please contact Zenseio before installation.

    • Related Articles

    • Installing a Multitech Gateway

      In order to setup your Multitech Gateway with your Zenseio Device, follow these simple steps: Fill-out request form, so Zenseio Support can onboard your Gateway in our system. Insert the SIM card into the SIM slot under the round clear plastic window ...

    • Multitech Conduit Gateway Troubleshooting

      Multitech Conduit LoRaWAN gateway should be connected to "P+D/OUT" port of the PoE Injector. If you have internet (from a router's ethernet), you can connect it to "Data/IN" of the PoE Injector. If you don't connect internet line to "Data/IN", the ...

    • Debug No Connectivity Issue on Multitech Conduit LoRa Gateway (ethernet only version)

      If the Multitech (ethernet-only) gateway completely stops connecting to the internet, not just our LoRa network server. Since this is an Ethernet-only gateway, the most likely failures are: Power failure (ie. PoE Injector failure, mains power loss - ...

    • What do the LED lights mean on Multitech Conduit IP67 gateways?

      LED Indicators Label Name Description PWR Power Solid (constant) green if unit is on indicating that DC power is present. STATUS Power Status Default condition: LED blinks when mLinux is fully loaded. LS (or L1) Link Status Varies with radio model. ...

    • Updates to Zenseio Device Hardware (2023)

      The latest models of Zenseio's LSMP & CSMP devices (2023, hardware version 4.1 designation on PCB) will ship with a few differences from previous models: Improved non-rechargeable battery: it has more capacity and better low-temperature performance, ...