I received my Zenseio devices. What do I do next?

I received my Zenseio devices. What do I do next?

Please open this link to get started and access documentation:

https://zenseio.com/start


Antenna must be attached to the device before turning on the power switch or a damage may occur!
  1. Do not detach the antenna until the power switch has been turned off.
  2. Do not power off the device until the Status lights have stopped blinking for 1 minute.

Newer Zenseio models may arrive with their battery in the box, not yet installed in the device. To learn how to install your battery or more about your device, see the Manuals Section of the Zenseio Knowledge Base. 


    • Related Articles

    • Instruction Manual for Zenseio LSMP-2103 Device

      1. Document revision 1.33 January 3, 2022 Copyright 2017-2023 Zenseio LLC 2. Introduction Zenseio LoRa Soil Moisture Pro (LSMP) device is providing long-range telemetry for SDI-12 soil moisture probes and other commonly used sensors using LoRaWAN ...

    • Instruction Manual for Zenseio CSMP-4103 Device

      1. Document revision 1.13 January 3, 2022 Copyright 2017-2023 Zenseio LLC 2. Introduction Zenseio Cellular Soil Moisture Pro (CSMP) device is providing long-range telemetry for SDI-12 soil moisture probes and other commonly used sensors using ...

    • How to Connect a Temperature Sensor to a LSMP or CSMP Device

      Temperature Sensor (Thermistor) Installation Currently, only thermistors sold by Zenseio are supported. The following installation is for this thermistor only. Select “Thermistor (1-Wire)” mode in the Zenseio mobile phone configuration app (ZenConfig ...

    • How to Use Modbus RS-485 Sensors with Zenseio LSMP and CSMP Devices

      We're thrilled to announce the integration of Modbus RS-485 industrial sensor support with firmware version 23 for the LSMP-2103 and CSMP-4103 devices. This update opens up new possibilities for industrial applications by allowing these devices to ...

    • Configuring Seametrics AG3000 Flow Meter for Zenseio Devices

      Wiring: For AG3000 flow meter with pulse output, connect as follows: Green (P3) Pulse + connect to GPI* (any GPI) White (P4) Pulse - connect to GND (next to GPI) Do not connect Red (P1) DC+ or Black (P2) DC- to Zenseio box. AG3000 is either ...