User Tips
Configuring the Optional GPS Sensor Using the Zenseio Mobile App
To learn how to Configure your GNSS Sensor, please refer to the GPS Sensor Section of the Zenseio Mobile App User Guide The GPS Tracker is an additionasl option available upon request, and does not come
Configuring Alerts for GPI Sensors Using the Zenseio Mobile App
I/O Mode - selects the functionality of the input: Off - the input is ignored Digital - a weak pullup voltage is supplied by device on the GPI input, and the input is sampled at Sensor Read Intervals. If the voltage is pulled externally close to 0 V ...
How to Configure VAUX Using the Zenseio Mobile App
5.3 VAUX Settings (LSMP/CSMP device only) If the device is equipped with auxiliary voltage generator inputs, VAUX pin provides output voltage to power or bias an external sensor. Generated Output Voltage - sets the power supply voltage for the ...
Checking Status Information Using the Zenseio Mobile App
You can test and check your device's status through an NFC connection using the Zenseio Mobile App, to do so, see the Showing Device Status Section of the Zenseio Mobile App Manual. You must be close enough to the device to use your phone's NFC ...
How to connect a GPI sensor to your LoRaWan device
To learn how to setup a GPI protocol compatible sensor with your LSMP device, see the GPI Sensor Setup Section of the LSMP Device User Manual.
Connecting a Soil Moisture Probe to your LSMP Device
To learn how to connect a soil moisture probe (or another SDI-12 compatible sensor) to your LSMP device, see the Soil Moisture Prob Setup section of the LSMP Device Manual.
How to Update Your Zenseio Device's Firmware
NOTE: Only Windows 10 or 11 is currently supported. This process will update your LSMP or CSMP device to the latest firmware version. It will also update the device configuration to the default one. The process is very easy and takes about 1 minute. ...
How to calculate pressure transducer PSI from 4-20mA output
Here is the formula for calculating pressure based on the value reading from 4-20mA pressure transducer: pressure = (current_reading - 4mA) * max_pressure / 16mA where max_pressure is the maximum pressure the sensor is rated to measure, eg. 100 psi, ...
How can I extend the battery life?
Zenseio devices use industrial-grade lithium batteries that have large energy capacity, last long time, and can function in a wide ambient temperature range. However, the battery life is heavily dependent on the radio signal strength (especially for ...
Recommendations for Boosting Antenna Signal
As the crops grow, we're increasingly seeing radio signal degradation, especially with the row crops, where the telemetry is not mounted high enough. Here is an app note showing how to best mitigate this situation. Please take the recommended actions ...